Jawbone Bluetooth Headset Intructions 

Jawbone Bluetooth Headset Instructions for Pairing and Talking on your Bluetooth Headset

Jawbone works with Bluetooth-enabled devices only. Prior to pairing your headset for the first time, please ensure that your mobile phone is Bluetooth capable and the Bluetooth feature is enabled.

The first time that you use Jawbone with your Bluetooth-enabled phone, you will have to “pair” them together. This is a procedure that exchanges information between your phone and the Jawbone so that they can work together. Pairing is only required the first time you use the Jawbone with your phone.

The headset pairing procedure will vary depending on the model of your mobile phone. Please refer to your mobile phone user guide for pairing instructions.

Steps for Pairing Jawbone:

1. Place Jawbone where it is no more than one meter
away from your mobile phone.

2. Ensure Jawbone is off (the LED status indicator
should not be flashing).

3. Activate your mobile phone’s Bluetooth function.
Please refer to your mobile phone user guide or for details.

4. Press and hold the ‘NOISE SHIELD BUTTON’
for 3 seconds until the LED status indicator alternately
flashes white and red. This means Jawbone is now in
pairing mode. This mode will last for 2 minutes or until
pairing is complete.

5. Set the mobile phone to search for all available
Bluetooth devices. When the search is complete, select
“Jawbone” from the list of devices shown.

6. Enter the passkey “0000” and press “OK” to pair
Jawbone with your mobile phone. When the pairing
is completed, Jawbone will beep and the LED status
indicator will then flash white rapidly eight times.

7. If prompted by the phone to connect, select “Yes”
(this will vary between phones).

8. Go back to your mobile phone’s main menu. For
certain mobile phone models, once the headset is
activated, a headset icon will be displayed on the
screen. You should now be able to make and receive
calls using Jawbone.

NOTE: After the initial pairing, the phone and Jawbone
will remember each other. Therefore you will not have to
pair your headset with your phone every time you use it.
Just select “Jawbone” from the list of paired devices and
connect to it.

IMPORTANT: If the pairing cannot be completed within
two minutes after the pairing mode has been activated,
Jawbone’s LED indicator will flash red and beep three
times. Jawbone will then turn off automatically. Please
repeat steps 2 to 8 above to pair Jawbone and the
mobile phone again.

Using Jawbone after it is Paired and connected

1. To answer a call, press the ‘TALK BUTTON’
once.

2. To end a call, press the ‘TALK BUTTON’ once.

3. If Jawbone is connected to the phone and you make
a call, the audio will automatically be routed to
Jawbone. To make a call using voice dialing, press the

‘TALK BUTTON’ once when Jawbone is in
standby.

4. Jawbone automatically enhances the volume of your
call depending on the noise of your environment. If you
want to adjust the volume of your call further, use your
mobile phone’s volume button or press the ‘NOISE
SHIELD BUTTON’ one time to increase the
volume by one level (there are a total of six levels).